Y14.5-2009By now, many of you have heard that ASME Y14.5-2009 has been released. The new version of the dimensioning and tolerancing standard for GD&T incorporates many significant changes, including:

  • New symbols and terms
  • Revisions to concepts, symbols, and terms
  • Clarification to existing concepts

Many companies are in the midst of cost-reduction programs and are under intense pressure to increase productivity. As a result, the timing of this new standard’s release has caused an unexpected challenge for industry. Changing dimensioning and tolerancing standards is a major effort, and the decision should be made with as much information as possible.

Here at ETI, companies have been requesting information about what is going on in industry relative to dimensioning and tolerancing standards. With that in mind, I have created a short survey to collect statistics regarding companies’ plans for either adopting the new standard or adopting ISO standards.

take the survey

When the survey is complete, I will share the results with all the survey participants. I will also provide a white paper of my personal insights on the benefits and risks of early adoption. It will discuss points to consider when deciding to adopt the new ASME standard or change to ISO standards.

I hope you will take a few minutes to complete this short, 10-question survey. The individual results will be confidential; only group data will be published.

Best regards,
Alex